FTDI Basic Breakout - 5V USB to UART 변환기로서 저희 제품중에서는 주로 STN1110 칩을 이용한 제품 개발시에 STN1110 개발 Board 와 함께 사용됩니다.
FTDI Basic Breakout - 5V는 FTDI 사의 FT232R 칩을 기반으로 PC의 USB를 사용 시리얼 통신을 할 수 있게 합니다.
반드시 이 모델을 사용하여야 하는 건 아니며, 핀배열만 맞다면, 어떤 종류의 USB to UART 보드를 OBD board에 써도 된다고 합니다
(Any USB to UART board with a compatible pinout, could be used with the OBD board, 고객 분중에서는 블루투스 모델을 쓰시는 경우도 있습니다)
관련 제품::
/goods/view?no=460 << STN1110 칩
/goods/view?no=459 << ECUsim 2000 ECU simulator
/goods/view?no=274 << OBDLink(USB)
/goods/view?no=498 << STN1110 개발 Board
관련 자료::
/board/view?id=board3&page=60&seq=886 << ECUSim 2000등을 이용한 Test 예제
(사용 제품: OBD-II 개발 보드 (STN1110기반) + ECUSim 2000 (CAN Protocol) + USB UART 변환기 + OBD 스캐너 케이블 및 기타 케이블)
아래는 제품에 대한 제조사 소개입니다.
FTDI Basic Breakout - 5V
sku: DEV-09716
Description: This is the newest revision of our FTDI Basic. We now use a SMD 6-pin header on the bottom, which makes it smaller and more compact. Functionality has remained the same.
This is a basic breakout board for the FTDI FT232RL USB to serial IC. The pinout of this board matches the FTDI cable to work with official Arduino and cloned 5V Arduino boards. It can also be used for general serial applications. The major difference with this board is that it brings out the DTR pin as opposed to the RTS pin of the FTDI cable. The DTR pin allows an Arduino target to auto-reset when a new Sketch is downloaded. This is a really nice feature to have and allows a sketch to be downloaded without having to hit the reset button. This board will auto reset any Arduino board that has the reset pin brought out to a 6-pin connector.
The pins labeled BLK and GRN correspond to the colored wires on the FTDI cable. The black wire on the FTDI cable is GND, green is CTS. Use these BLK and GRN pins to align the FTDI basic board with your Arduino target.
This board has TX and RX LEDs that make it a bit better to use over the FTDI cable. You can actually see serial traffic on the LEDs to verify if the board is working.
This board was designed to decrease the cost of Arduino development and increase ease of use (the auto-reset feature rocks!). Our Arduino Pro boards and LilyPads use this type of connector.
One of the nice features of this board is a jumper on the back of the board that allows the board to be configured to either 3.3V or 5V (both power output and IO level). This board ship default to 5V, but you can cut the default trace and add a solder jumper if you need to switch to 3.3V.
Documents: